NF T35-508-8-1997 涂料及相关产品应用前钢基体的预处理.非金属喷砂清理磨料规范.第8部分:橄榄砂(ENISO11126-8)

上一篇: NF X50-160-1997 质量和管理.质量手册的编制指南
下一篇: NF T35-508-6-1997 涂料和相关产品使用前钢基体的预处理.非金属清理磨料的规范.第5部分:炼铁炉渣(ENISO11126-6)

Product Code:SAE J2337/3
Title:Connections for Fluid Power and High Pressure Use-Ports, Stud Ends, and Plugs With Iso 261 Threads and O-Rings Sealing-Part 3: Port Plug Requirements, Dimensions, Design, and Test Methods
Issuing Committee:Hydraulic Tube Fittings Committee
Scope: PurposeThis part of SAE J2337 specifies dimensions, design, and performance requirements for eight plugs using a conical seal to insure leak proof performance with a design factor of 4 to 1.Field of ApplicationThese connectors are intended for general and hydraulic systems on industrial equipment and commercial products, where elastomeric seals are acceptable to overcome leakage and variations in assembly procedures. These connectors are capable of providing leak proof full flow connections in hydraulic systems operating from 95 kPa vacuum to the working pressures shown in Table 1. Since many factors influence the pressure at which hydraulic systems will or will not perform satisfactorily, these values should not be construed as guaranteed minimums. For any application, it is recommended that sufficient testing be conducted and reviewed by both the user and manufacturer to ensure that the required performance levels are met.For use of these connectors in conditions outside the pressure and temperature limits specified, contact the manufacturer.
Rationale: PurposeThis part of SAE J2337 specifies dimensions, design, and performance requirements for eight plugs using a conical seal to insure leak proof performance with a design factor of 4 to 1.Field of ApplicationThese connectors are intended for general and hydraulic systems on industrial equipment and commercial products, where elastomeric seals are acceptable to overcome leakage and variations in assembly procedures. These connectors are capable of providing leak proof full flow connections in hydraulic systems operating from 95 kPa vacuum to the working pressures shown in Table 1. Since many factors influence the pressure at which hydraulic systems will or will not perform satisfactorily, these values should not be construed as guaranteed minimums. For any application, it is recommended that sufficient testing be conducted and reviewed by both the user and manufacturer to ensure that the required performance levels are met.For use of these connectors in conditions outside the pressure and temperature limits specified, contact the manufacturer.【英文标准名称】:Glossaryofbasictermsusedinelectrotechnology
【原文标准名称】:电子技术基本术语汇编(基本术语)
【标准号】:JISC5600-2006
【标准状态】:现行
【国别】:日本
【发布日期】:2006-11-20
【实施或试行日期】:
【发布单位】:日本工业标准调查会(JP-JISC)
【起草单位】:TechnicalCommitteeonElectronics
【标准类型】:()
【标准水平】:()
【中文主题词】:术语;词典;电子工程;通信设备;远程通信;电信系统
【英文主题词】:
【摘要】:この規格は,電子技術に用いる主な基本用語とその定義について規定する。
【中国标准分类号】:L04;M04
【国际标准分类号】:01_040_33;33_020
【页数】:110P;A4
【正文语种】:日语